Alnico 5 Assembly Set Single Pickup Large Potentiometer Screws Included

This is a complete set of pickup assemblies for a Stratocaster, equivalent to SSS (single-coil, single-coil, single-coil) size.
The magnets are all Alnico 5.

This item is brand new and unused.
It is pre-wired and in perfect working condition.
It has not been installed on a guitar yet, and continuity output has been confirmed for all positions.

Simply connect the positive/negative wires to the jack and the string ground (usually connected to the spring claw on the back), and it's ready to go, making installation very easy.

It features 1 volume, 2 tone controls, and a 5-way switch. The lever provides 3 standard positions plus 2 half-tone positions, just like a typical Stratocaster.

The resistance values are approximately: Front 5.7kΩ, Center 5.7kΩ, Rear 7.1kΩ (these are published values and may differ slightly from actual measurements).

The pickguard is 3-ply black.
The pickups are also black.

The item will be shipped via Yu-Packet Post, which requires a thin protective box (approximately less than 4cm thick, with cushioning). Due to thickness restrictions, the lever switch will be removed for shipping.
Reattaching it involves only a few screws, so it should be a simple and straightforward process.
When installing on your guitar, you will need to solder the wiring connections.

Additionally, while the pickguard is stated to be Fender/Squire size, it is not an official Fender product, and there are no strict universal standards. Therefore, there might be slight alignment discrepancies depending on your specific guitar and its manufacturer. Please be prepared to make adjustments as needed.
Alternatively, you can always reuse your original pickguard.