Tanaka Gas Gun (Pegasus) Colt Python 20mm Rib Mount Rail Recessed Type

This is a 20mm rib mount rail for the Tanaka Gas Gun (Pegasus System) Colt Python .357 Magnum.
*This is the type with a dent on the upper surface. A dent-free type is also listed separately.

It is attached by inserting it into the rib holes and tightening with M1.2-2.5mm screws (a precision Phillips screwdriver is required). The dimensions are snug and tight. If a scope mount is always attached and tightened to this mount rail, the M1.2 screws may not be necessary. (The M1.2 screws will be shipped detached and secured with tape; please be careful not to lose them when opening.)

It cannot be attached to the foremost rib hole near the muzzle.

The rail can be attached to the rib holes by shifting it about 1cm to either the front or back width of the rib holes.

The image shows an example of it attached to a S&W Python .357 Magnum. The listing is for the mount rail (front and rear, 2 pieces as a set) only. The gun itself is not included in the listing.

As I only own a 4-inch model of the Tanaka Gas Gun (Pegasus System) Python .357 Magnum, the image only shows the 4-inch model.
It cannot be attached to products from manufacturers other than the Tanaka Gas Gun (Pegasus System).

This product is made with a 3D printer using PLA material.
Please only bid if you understand that this is a 3D printed product. It may have layer lines, extrusion marks, burrs, stringing, fuzziness, printing irregularities, etc., characteristic of 3D printing, as well as cutting marks from fitting and adjustment.
It may deform in environments above 70°C.

I am not responsible for any injuries or damages caused by this product.

Product specifications are subject to change without notice.

Please, no claims, no returns.