??★ Stylish Aquarium Stand for Enjoying with Children ★?? With Light Stand & LED Lighting

★ This aquarium stand is made to order.

We may cancel your order if we are unable to procure the necessary materials after you place your order. Please understand this in advance.

If we have finished products in stock, we can ship them within 1-2 days. If you are in a hurry, please check the stock status in the comments.


● About compatible aquarium sizes

This aquarium stand is compatible only with aquariums with a bottom size of 30cm x 30cm or less.


● About the light stand (antique pipe style)

Material: Steel (galvanized)
Surface treatment: Epoxy resin

Vertical long side: Approx. 64cm
Vertical short side: Approx. 15cm (including LED lighting)
Horizontal side: Approx. 23cm

The distance from the LED light surface to the top of the aquarium stand is approximately 50cm.

*The red handle is decorative.

The aquarium stand and light stand will be shipped separately.
The base plate of the light stand is screwed to the top board of the aquarium stand. Please connect the light stand body after unpacking.

Do not overtighten the connections due to the screw threads. Adjust to your preferred angle with a slight looseness.


● About LED lighting

5.5W
Daylight white 5000K
CRI95
550lm
Non-dimmable
Wide angle 90°
Lifespan: 30,000 hours
Cord length: Approx. 150cm

*Replacing the LED lighting is not recommended. You are responsible for any malfunctions caused by removal.

*Pulling strongly on the power cord may cause it to break. We will test the power before shipping. You are responsible for any malfunctions caused by breakage.


● About the cabinet (storage compartment)

The upper shelf has a back panel.
There is a cord hole (with cover) approximately 6cm in diameter in the center of the back panel.

The lower shelf does not have a back panel.
Internal dimensions: Width approx. 26cm
Depth approx. 37cm
Height approx. 37.5cm


● About the maintenance plate

A maintenance plate is stored on the underside of the top board (the ceiling of the upper cabinet shelf). It is made of PET resin and is highly water-resistant.

*Due to the structure, the plate is tight to insert and remove. Please refer to the following method for a tip on how to pull out the plate:

① Turn both palms upwards.
② Place your thumbs on the front edge of the top board.
③ Place your other fingers under the plate.
④ Apply force with your thumbs towards the back and your other fingers towards the front.